Sweet Home 3D Forum - View Thread


	Documentation


	Support


	About

Sweet Home 3D Forum

No member browsing this thread

Thread Status: Active
Total posts in this thread: 3

[ ]

Author

This topic has been viewed 3633 times and has 2 replies

mga56grg
Newbie

Joined: May 12, 2011
Post Count: 9
Status: Offline


extraneous triangle

when viewing in the 3D panel (aerial visit), some of my floor create extra opaque triangles (default grey), which extend from the floor to the ceiling of a nearby wall. if i rotate the view, the extra panels may or may not disappear temporarily (depending upon the view. i have found this to go away if i unclick the 'display ceiling' box, but obviously there is something else incorrect or unaligned with my models. any idea?

[Jul 7, 2011, 6:45:15 PM]

[Link]

hansmex
Advanced Member

Netherlands
Joined: Sep 26, 2009
Post Count: 4002
Status: Offline


Re: extraneous triangle

Marshall,

The triangles are (most probably) caused by the ceiling(s) of (a) room(s) with walls of unequal height.
Solution 1: Give all walls of a room the same height.
Solution 2: Make the ceilings invisible.

Hans
----------------------------------------
Hans

new website - under constuction
hansdirkse.info

[Jul 7, 2011, 7:22:03 PM]

[Link]

mga56grg
Newbie

Joined: May 12, 2011
Post Count: 9
Status: Offline


Re: extraneous triangle

thanks for this Hans. Making them invisible does the trick. FYI the room i was modeling is actually a patio off the back of the house, and attached to the main house. so there is a room of 1 inch height which allows me to draw a floor of brick texture. maybe i should not not use the house wall for a segment of my patio.

[Jul 7, 2011, 8:25:25 PM]

[Link]

Current timezone is GMT
May 19, 2025, 7:06:32 AM