Sweet Home 3D Blog

This blog presents news and tips about Sweet Home 3D.

Add a comment


Avatar: Darius

Re: Sweet Home 3D 5.5

I'm sorry if I don't understand you well but for example when I choose to draw a wall of 60cm thicknes and the "cross" starts to measure from the inner side of the wall as a reference point and then after the desired measure I decide to click again and draw another wall at 90, I don't see how it is a problem for the computer to draw that wall because it don't need to anticipate the next wall since I'm pointing at it with my next move where I want that wall to be drawn. It should only foolow that cross and draw it calculating the outer measure of the wall taking the thickness I gave into account. So whenever I click that should be the ancoring point to draw the next wall like it is drawing now but not from the center.

The method with the Wall creation tool is not bad when having a room with walls that have the same thickness but this is not in my case. And if you edit the measurements manually then the properties of the room on the other side of the wall are distorted.

Please try this floorplan site: https://www.homestyler.com/floorplan/?&lang=en_US... and it can do exactly what I ment (choosing to draw a wall from the inner line and from the center) so I hope that if they can do it then SH3d could have this feature too and it would be perfect. :-)

Best regards.

Re: Sweet Home 3D 5.5

HTML : b, strong, i, em, blockquote, br, p, pre, a href="", ul, ol, li, sub, sup
OpenID Login
E-mail address
Remember me Yes  No 

E-mail addresses are not publicly displayed, so please only leave your e-mail address if you would like to be notified when new comments are added to this blog entry (you can opt-out later).

    Get Sweet Home 3D at SourceForge.net. Fast, secure and Free Open Source software downloads
© Copyright 2006-2020 eTeks - All rights reserved